132984980.qxd 23/09/2005 16:44 Pagina 24
Emergency emptying out
If the water is not discharged (pump is blocked, filter
or drain hose are clogged), proceed as follows to
empty out the machine:
? pull out the plug from the power socket;
? close the water tap;
? if necessary, wait until the water has cooled;
? place a bowl on the floor;
? put the drain hose end into the bowl and let the
water come out.
Should it not be possible to have access to the drain
hose because, for example the appliance is built in
the kitchen furniture, slightly loosen the drain filter
after placing a bowl on the floor to let the water come
out slowly.
At the end screw the filter again.
Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:
? Close the water tap and unscrew the water inlet
hose from the tap.
? Place the end of the drain hose and the inlet hose
in a bowl placed on the floor.
? Select the DRAIN programme and run it until
the machine stops.
? Turn the programme selector dial to RESET O.
? Press the ON/OFF button to switch the
machine off.
? Remove the plug from the power socket.
? Screw the water inlet hose back on and put the
drain hose back in its place.
By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the parts involved.
When you use the machine again, make sure that
the ambient temperature is above 0°C.
24 |
ACEC
