can vary by ?6% of the rated voltage.- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
Periodic cleaningPeriods of non-operation
subsequent modifications;
For operation with different voltages, a suitably sized
Clean the inside with warm water and bicarbonate of
When the appliance is not in use for long periods,
auto-transformer must be used.- 89/336 EEC of 3.5.89 (Electromagnetic
soda. Rinse and dry thoroughly.
take the following precautions:
Compatibility Directive) and subsequent
The appliance must be earthed.
modifications.
remove the plug from the wall socket;
DefrostingThe power supply cable plug is provided with a
remove all food;
contact for this purpose.
The freezer compartment, however, will become
defrost and clean the interior and all accessories;ATTENTION!
progressively covered with frost. This should beIf the domestic power supply socket is not earthed,
removed with the special plastic scraper provided,leave the door ajar to allow air to circulate to preventconnect the appliance to a separate earth inIt must be possible to disconnect the appliance from
whenever the thickness of the frost exceeds 4 mm.unpleasant smells.compliance with current regulations, consulting athe mains power supply; the plug must therefore be
During this operation it is not necessary to switch offspecialist technician.easily accessible after installation.
the power supply or to remove the foodstuffs.
The Manufacturer declines all responsibility if
However, when the ice becomes very thick on thethe above safety precautions are not observed.
inner liner, complete defrosting should be carried out
This appliance complies with the following
and it is advisable to carry out this operation when
E.E.C. Directives:
the appliance is empty.
- 87/308 EEC of 2/6/87 relative to radio interference
To carry out complete defrosting of the freezersuppression.
compartment proceed as follows:
1. pull out the plug from the wall socket or turn the
Fitting the decor panel
thermostat knob to the �OE setting;
2. remove any stored food, wrap it in several layersD068Preliminary requirement: the over all dimensions of
of newspaper and put it in a cool place;
the decor panel must be 1-2 mm less than those of
3. leave the door open, insert the plastic scraper inthe door, with a maximum thickness of 4 mm.
the appropriate seating at the bottom centre,Important:
With the refrigerator door closed, unscrew the
placing a basin underneath to collect the defrost
screws securing the removable side piece of the
water;Never use sharp metal tools to scrape off frost
frame to the door. Remove this side piece and slide
from the evaporator as you could damage it.
4. when defrosting is completed, dry the interior
the decor panel into place, after having slackened
thoroughly and refit the plug; keep the scraper forDo not use a maechanical device or any artificial
the remaining frame screws; push the panel fully
future use;means to speed up the thawing process other
home and secure the frame to the door, includingD243
5. turn the thermostat knob back to the requiredthan those recommended by the manufacturer.
the side piece previously removed.
setting or replace the plug in the power socket.
A temperature rise of the frozen food packs,
1
After letting the appliance run for at least half an
during defrosting, may shorten their safe
hour, replace the previously removed food into
storage life. s
the compartment.
Door reversibility
The applianceOs door have been locked in position
2
CUSTOMER SERVICE AND SPARE PARTSfor transport by means of pins on both sides.
Right hand door opening
If the appliance is not functioning properly, checkopening is not obstructed (see ODefrosting�
that:section).
Remove the upper and lower screws (1-5) and
Y the plug is firmly in the wall socket and the mainsY If your appliance is still not working properly afterpivots (2-6) with the safety washer (4) on the left
D561
side. Remove the door stop hinge (3).
power switch is on;making the above checks, contact the nearest
service centre.
Y there is an electricity supply (find out by plugging
in another appliance);To obtain fast service, it is essential that when you
3
apply for it you specify the model and serial number
Y the thermostat knob is in the correct position.
of your appliance which can be found on the
Y If there are water drops on the bottom of theguarantee certificate or on the rating plate located
cabinet, check that the defrost water draininside the appliance, on the bottom left-hand side.
6
4
INSTALLATION
5
LocationElectrical connectionD562
The appliance should be installed well away fromBefore plugging in, ensure that the voltage and
sources of heat such as radiators, boilers, directfrequency shown on the serial number plate
sunlight etc.correspond to your domestic power supply. Voltage
1415 |